Bioimpedance Scale Body Fat Calculator

Clinical calculation support · Verify results before clinical use

Body Fat Estimation

Enter the patient's measurements to estimate body fat percentage using BMI, age, and sex.

The published equation uses a binary sex coefficient.
Reset

How to interpret this estimate

The calculator applies the adult Deurenberg equation to estimate body-fat percentage from body mass index (BMI), age, and sex. BMI is calculated from weight and height.

Equation: Body fat (%) = 1.20 × BMI + 0.23 × age − 10.8 × sex − 5.4; male = 1 and female = 0.

Important limitations

  • This calculator does not measure electrical resistance or reactance and therefore is not a bioelectrical impedance analysis (BIA) device.
  • It provides a population-based estimate, not a diagnostic measurement of body composition.
  • Prediction error can be clinically meaningful and may differ by body habitus and population. The original study reported a standard error of estimate of approximately 4.1 percentage points for the adult equation.
  • For actual BIA results, use a validated device and equation appropriate to the individual and follow the manufacturer's measurement protocol.

References

Deurenberg P, Weststrate JA, Seidell JC.

Body mass index as a measure of body fatness: age- and sex-specific prediction formulas. British Journal of Nutrition. 1991;65(2):105–114.

doi:10.1079/BJN19910073
Kyle UG, et al.

Bioelectrical impedance analysis—part I: review of principles and methods. Clinical Nutrition. 2004;23(5):1226–1243.

doi:10.1016/j.clnu.2004.06.004
Kyle UG, et al.

Bioelectrical impedance analysis—part II: utilization in clinical practice. Clinical Nutrition. 2004;23(6):1430–1453.

doi:10.1016/j.clnu.2004.09.012
Clinical disclaimer: This calculator is intended for educational and supportive clinical use. It does not replace direct body-composition assessment or clinical judgement. Do not use this estimate alone to diagnose obesity, malnutrition, or other clinical conditions.