CTA-Plaque Volume Index (PVI) Calculator

Clinical calculation support · Verify results before clinical use

Calculate plaque burden

Enter plaque and vessel volumes measured over the same coronary segment or region of interest.

%Volume index

Total segmented atherosclerotic plaque volume.

mm3

Total vessel volume corresponding to the same measured region.

mm3
Reset calculator

About plaque volume index

Coronary CT angiography (CCTA) can quantify coronary atherosclerotic plaque volume and normalize it to vessel volume. The resulting percentage is commonly described in the literature as percent atheroma volume (PAV) or plaque burden, although terminology and segmentation conventions may differ between studies and software platforms.

Formula

PVI (%)(Total Plaque Volume ÷ Total Vessel Volume) × 100
TPVTotal plaque volume, measured in mm3.
TVVTotal vessel volume corresponding to the same region of interest, measured in mm3.

How to interpret the result

  • The displayed percentage is a mathematical estimate of plaque volume relative to the measured vessel volume.
  • Higher values indicate a greater relative plaque burden for the region measured.
  • Use consistent segmentation boundaries and volume definitions when comparing measurements or serial CCTA studies.
  • Do not use this percentage alone to estimate an individual patient's event probability or to determine treatment.

Important limitation of cutoffs

The original calculator used thresholds of <20%, 20–39%, and ≥40% to label plaque burden. The sources listed here support quantitative plaque assessment but do not establish those three thresholds as a universal clinical risk classification. These labels have therefore not been retained as validated categories.

References

van Rosendael AR, et al.Percent atheroma volume: Optimal variable to report whole-heart atherosclerotic plaque burden with coronary CTA, the PARADIGM study. J Cardiovasc Comput Tomogr. 2020;14(5):400–406. doi:10.1016/j.jcct.2020.01.012.PubMed record
Leipsic J, et al.SCCT 2021 Expert Consensus Document on Coronary Computed Tomographic Angiography. J Cardiovasc Comput Tomogr. 2022;16(1):4–18. Consensus document describing the clinical role of CCTA plaque characterization and burden assessment.Full-text article
Clinical disclaimer: This tool performs a volume-ratio calculation and is intended for educational and clinical support use. It is not a stand-alone diagnostic or prognostic instrument. Confirm source measurements and apply clinical judgement; quantitative results can vary with acquisition, segmentation, software, and vessel-region definitions.